Please e-mail or phone your repair parts requirements for a quick quotation to: info@cmsengineeredproducts.com  or  (P) 317.292.2914

CONTROL VALVES Globe Valves

Available sizes (Series ED & ET): 1”, 1½”, 2”, 2½”, 3”, 4”, 6” and 8”;

Available sizes (Series EZ): 1”, 1½” and 2”, 2½”, 3" and 4";

Single port, globe style body with metal or composition seats and a balanced push-down-to-close valve plug.

There are three styles of valves available:

• Series ED valves are intended for general control applications over a wide variety of temperature and pressure drops.
• Series ET valves are intended for applications requiring low leakage rates with composition seating (TFE) for tight shutoff requirements or metal-to-metal seating for higher temperature capabilities. The valve plug has a two-piece upper seal.
• Series EZ valves are globe style with integral end connections, post guiding, and quick-change trim. These valves are used in chemical or hydrocarbon processing applications or in applications that require control of non-lubricating, viscous, or other hard-to-handle fluids.

The flow direction for standard cages is flow down, and the flow direction for the Series EZ is up through the seat ring, with the following flow characteristics available: linear, quick-opening, and equal percent.

The end connections available are ANSI Class 150, 300 and 600 Raised Face or Ring Type Joint flanges as per ASME B16.34-1996.

Valve bodies are available in LCC, WCB (carbon steel) and 316 stainless steel materials.

CVS Controls manufactures control valves and associated instrumentation products to specification that facilitate the direct replacement with FISHER® process control equipment.

* FISHER® is a registered trademark of Fisher Controls International Inc. Fisher Controls International Inc. is not affiliated with CVS Controls Ltd. in any manner. Fisher Controls International Inc. has not reviewed, sanctioned or endorsed any products manufactured, reconditioned, sold or marketed by CVS Controls Ltd.